SSANGYONG Y200 Manual page 1526

SSANGYONG Y200
YAD6A270
B A 1
2
YAD6A280
YAD6A290
YAD6A300
POWER STEERING 6A-15
3. Completely tighten the mounting bolt/nut which is
tightened slightly.
Notice: First tighten the center bolt/nut and then
tighten bolt/nut as specified torque.
Installation Notice
Center Bolt/Nut
Left Bolt/Nut
4. Install the steering lower shaft to the gearbox. The
joint bolt on the lower shaft should be tightened
toward 'B' (threaded) from 'A' (non-threaded).
Installation Notice
Tightening Torque
Notice: When installing the lower shaft to the gear
box, the joint bolt (1) should be installed anto the
gearbox pinion shaft splines.
5. Install the tie rod end in steering knuckle. Tighten
the sloted nut and then insert the new split pin.
Tightening Torque
Installation Notice
6. Install the clamp of return pipe in front end panel.
Installation Notice
Tightening Torque
70 - 90 N•m
(52 - 66 lb-ft)
70 - 90 N•m
(52 - 66 lb-in)
25 - 30 N•m
(18 - 22 lb-ft)
35 - 45 N•m
(26 - 33 lb-ft)
7 - 10 N•m
(62 - 89 lb-in)