SSANGYONG Y200 Manual page 1288

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-193
20. Assemble the pump to the pump cover.
21. Tighten all bolts and the crescent screw finger
tight, ensuring that the pump is flush against the
pump cover. Tighten the bolts and the screw to
specification in the order. (A-F)
Installation Notice
Tightening
Torque
22. Install the pump to transmission case gasket onto
the case.
23. Fit the 'O' ring to the pump cover outer diameter.
KAA5A1L0
24. Install the pump and cover assembly over the
input shaft being careful not to damage the sealing
rings. Apply additional Loctite 202 or equivalent
as required to the pump cover to case bolts. Install
and tighten bolts to specification.
Installation Notice
Tightening Torque
KAA5A1M0
25. Check that the transmission end float is 0.50 -
0.65 mm. If the unshimmed end float clearance is
greater than specification, shims are to be placed
between the No. 4 bearing and the input shaft
bearing surface. If the end float clearance is less
than 0.5 mm then the transmission has been
assembled incorrectly or the parts are out of
specification.
26. Perform the following steps to check the end float :
a. Attach a dial indicator to the front of the trans-
mission case with the stylus resting on the end
of the input shaft.
b. Apply a force of approximately 250 N or 25 kg
KAA5A1N0
to the input shaft.
c. Zero the dial indicator.
d. Place a small lever behind the forward clutch
cylinder and lever the cylinder forward.
e. The measurement recorded on the dial indicator
is the transmission end float or clearance be-
tween the No.4 bearing and the converter sup-
port tube.
27. On completion of this procedure, adjust the front
and rear bands to specifications. Refer to "Front
and Rear Band Adjustment" in this section.
Bolt (A-E) : 24-27 N•m (18-20 lb-ft)
Screw (F) : 13-16 N•m (10-12 lb-ft)
24-34 N•m (18-25 lb-ft)