SSANGYONG Y200 Manual page 1477

Step
1. Turn the ignition switch to OFF.
2. Disconnect two connectors of the TOD and 7-pin
connector under the body.
3. Measure the resistance between following terminals:
5
•
A8 (TOD) and 1/2 (7-pin connector)
•
B8 (TOD) and 6/7 (7-pin connector)
Is the resistance equal to specified value?
4. Measure the voltage between A8 and B8 of TOD
connector and ground.
Is the resistance below the specified value?
Repair any short to circuit.
6
Is the repair complete?
Measure the resistance between terminals of the male
white 7-pin connector.
•
Terminal 6 and terminal 3
•
Terminal 6 and terminal 2
•
Terminal 3 and terminal 2
7
•
Terminal 7 and terminal 5
•
Terminal 7 and terminal 1
•
Terminal 5 and terminal 1
Is the measurement within specified range?
Replace front or rear propeller shaft speed sensor.
8
Is the repair complete?
1. Replace the TOD.
2. Turn the ignition switch to OFF.
3. Connect the scan tool to data link connector (DLC)
and follow the directions given in the scan tool
9
manual.
4. Turn the ignition switch to ON.
5. Delete and request DTC with scan tool.
Is the repair complete?
SSANGYONG Y200
Action
TRANSFER CASE - TOD 5D2-55
Value Yes
0 Ω
∞
Go to Step 7
- System OK
5 ~ 6 MΩ
5 ~ 6 MΩ
9 ~ 10 kΩ
5 ~ 6 MΩ
5 ~ 6 MΩ
9 ~ 10 kΩ
Go to Step 9
- System OK
- System OK
No
Go to Step 6
Go to Step 7
Go to Step 8
-
-