SSANGYONG Y200 Manual page 1824

9D-68 BODY ELECTRICAL
4. Attach tape of repair of grid line properly.
•
Attach tape to have a same width with grid line.
5. Spread material of repair with wooden spoon.
6. Remove tape carefully.
YAD9D1Q0
7. Heat up the section which is repaired, keep
distance 25 mm from this section, with drier below
149¡É for 1-2 minutes
Notice: Repair material of grid line dry up with
heating, while is heating repairing section trim
which is linked should be protected from heating,
pay attention to deformation of interior trim
8. If grid line of repairing is discolored, after
spreading coating of paint of iodine on section
discolored, if get spreading out of grid line, after
half hour is passed, clean up grid line with soft
wiper.
YAD9D1R0
9. Check if grid line is repaired or not, operate glass
defogger of back door.
Notice: Until repair material is dried up completely,
this is needed 24 hours at least, section repaired
should be protected from unnormal material.
YAD9D1S0
Repair of defogger of tail gate
Copper line of glass defogger have reinstallation
available with soldering, soldering consists of 30 %
silver solder and rosin solvent
1. Disconnect negative cable of battery.
2. Scrape the around section of repair with wooden
spoon
3. After spreading on the copper line, clean up on
the section which is repaired with brush.
YAD9D1T0
SSANGYONG Y200