SSANGYONG Y200 Manual page 1490

5D2-68 TRANSFER CASE - TOD
Removal & Installation Procedure
1. Disconnect (-) cable from battery.
2. Lift on vehicle and make sure on safety.
Notice: Be careful for catalytic converter due to
high temperature after driving or engine running.
3. Prepare a vessel to drain transfer case and manual
transmission oil.
4. Release drain plug and drain transfer case and
manual transmission oil.
If planar damper is installed, unscrew 4 bolts and
remove the planar damper.
YAD5D210
Notice: Oil drain should be along with whole
transfer case disassembly and assembly.
5. Disconnect transmission extension wiring
connector back side transfer case.
Notice: When disconnect connector, make sure
on direction of locking tab towards inside.
6. Disconnect shift motor/clutch coil connect (Black
7 pin) connector upper backside.
7. Disconnect front and rear speed sensor connector
(white 7 pin).
03E-019
YAD5D220
8. Disconnect speedometer sensor connector right
upper side.
03E-019
YAD5D230
SSANGYONG Y200