Sir System Operation; Airbag Module Discard - SSANGYONG Y200 Manual

SIR SYSTEM OPERATION

The supplemental inflatable restraints (SIR) system is
a safety device used in conjunction with the seat belts.
The airbag does not replace the function of the seat
belt. The driver and the passengers must always fasten
their seat belts and adjust them for a proper fit.
Deployment Condition
Airbag is designed to protect the driver and the front
seat passenger in the event of a significant frontal
impact to the vehicle. The airbags deploy if the force
is applied from a direction within 30 degrees of the
vehicle's centerline and above 25 km/h (15 mph)
speed. In case of the 0 degree frontal concrete barrier,
airbag may deploy above 25 km/h (15 mph) speed.
The side airbag deploys if the side impact is applied
above 30 km/h.
Condition That Deployment may not be
Occurred
•
Rear Impact
•
Slight impact or partial impact
•
Incline impact
•
Overturn and fall accident
•
Impact on the material that may be possible to
absorb a lot of impact energy (styrofoam, empty
drum can, etc.)
SSANGYONG Y200

AIRBAG MODULE DISCARD

Airbag Module Deployment (Inside Vehicle)
Deploy the airbag before disposing of them. If a vehicle
to be scraped, the airbag may be deployed inside the
vehicle.
•
Before deploying the airbags, remove all loose
objects from the airbag's expansion area.
•
Deploy the airbags with the vehicle doors closed
and the side windows open.
•
Deploy the airbags only in an evacuated area.
Service personnel who must be present during the
deployment should be at least 10 meters (33 feet)
in front of the vehicle.
•
Do not connect the voltage source until after having
completed all other preparations for the deployment
of the airbags.
•
Allow a deployed airbag module or pretensioner to
cool for at least 30 minutes before handling.
YAD8B020
•
If the deployment fails, disconnect the voltage
source and wait 5 minutes before approaching the
vehicle.
Airbag Module Discard (Driver)
1. Disconnect the battery cable and place the vehicle
battery at least 10 meters (33 feet) away from the
airbag module.
Notice: If the airbags are not disconnected, service
cannot begin until one minute has passed after
disconnecting power to the SDM. If the airbags are
disconnected, service can begin immediately
without waiting for one-minute time period to expire.
Failure to temporarily disable the SRS during service
result in unexpected deployment, personal injury
and otherwise unneeded SRS repair.
2. Remove the lower cover of the steering column.
YAD8B030
3. Cut two wires between the airbag and the contact
coil.
4. Strip 13 mm (0.5 inch) of the insulation from the
end of the wires leading to the contact coil.
RESTRAINTS 8B-3
YAD8B040