Repair Of The System - SSANGYONG Y200 Manual

9D-86 BODY ELECTRICAL

REPAIR OF THE SYSTEM

Switch of Outside Mirror
1. Remove upper section of switch (between IP and
section of ground ) with driver.
Notice: switch is attaching on the upper section
YAD9D3G0
2. After disconnecting the connector, remove switch
assembly.
3. Install the reverse order of removal
YAD9D3H0
Switch of Center IP
1. After panel of center IP is removed, each switch
can be separated.
2. After center panel is removed, disconnect
connector
3. Separate each switch from removed panel.
4. Install the reverse order of removal.
Notice: While each switch is checked, refer to the
following circuit, and then check whether apply
an electric current or not,
•
Switch of front fog lamp
YAD9D3J0
Digital Watch
1. Remove the center panel
2. After releasing fixing screw from the panel, remove
the digital watch.
3. After digital watch is fixing on the panel, link the
connector, and then install panel on the panel of
IP.
YAD9D3K0
SSANGYONG Y200