SSANGYONG Y200 Manual page 1294

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-199
25. Check the alignment of the detent roller and the
manual lever quadrant.
26. Connect the solenoid wiring as detailed below:
Solenoid 1 - red
Solenoid 2 - bIue
Solenoid 3 - yellow
Solenoid 4 - orange
Solenoid 5 - green
Solenoid 6 - violet
Notice: All hardware must be correctly installed and
torqued to specification.
KAA5A2A0
Oil Filter and Pan Assembly
Notice:
•
Replace the filter whenever rebuilding a
transmission where a significant amount of
mechanical damage has occurred.
•
To aid the assembly of the pan gasket, use a small
amount of Vaseline at the pan/gasket interface. This
ensures that the gasket remains on the pan ridge.
Do not over torque pan bolts as this may distort
the pan and cause leaks.
•
Ensure that the internal line pressure plus in the
valve body is fitted.
KAA5A510
1. Lubricate the oil filter sealing ring with automatic
transmission fluid.
2. Carefully assemble the oil filter to the valve body.
The spigot must not lean on one side while being
fitted.
3. Secure the oil filter assembly with the retainer.
4. Check that the magnet is located in the dimple in
the corner of the oil pan.
5. Assemble the gasket on the pan lip. The gasket
must be free of any distortion when installed.
KAA5A2B0