4Wd Low Indicator Blink Steadily - SSANGYONG Y200 Manual

Circuit Description
When the 4H/4L switch turned from 4H (4L) to 4L (4H)
electric shift starts and 4WD LOW indicator begin to
blink until the shifting is completed or canceled. If 4H
to 4L shifting is completed the 4WD LOW indicator
will illuminated and 4L to 4H shifting is completed it
will be turned off.
If shifting fails the 4WD LOW indicator will blink
steadily until the shifting is completed or canceled.
Step
1. Stop the vehicle.
2. Turn the 4H/4L switch to original position.
1
Does the 4WD LOW indicator stop blinking?
1. Make sure the vehicle stopped completely.
2. Set the shift lever to N (neutral) and wait more than 2
seconds.
2
3. Turn the 4H/4L switch.
Does the 4WD LOW indicator blink and stop after
complete shifting?
•
4H —> 4L: 4WD LOW indicator illuminates.
•
4L —> 4H: 4WD LOW Indicator turns off.
1. Starts TOD Diagnostic System Check.
3
2. If there were no trouble code, replace TOD.
Is the repair complete?
SSANGYONG Y200

4WD LOW INDICATOR BLINK STEADILY

Action
TRANSFER CASE - TOD 5D2-33
Diagnostic Aids
The 4WD LOW indicator shows that the transfer case
is operating in low range. And the indicator will blink
while shifting from low to high range or high to low
range. If the indicator blinks steadily it warns the
shifting command and real position of the shift motor
or position encoder are not matched.
Value
- Go to Step 2
-
-
Yes No
Go to Step 3
System OK Go to Step 3
System OK -