SSANGYONG Y200 Manual page 1760

9D-4 BODY ELECTRICAL
8. While harness is separated, connector should be
pulled, harness should not be pulled, like the
picture.
YAD9D080
9. While connector is separated with the lock, pushing
arrow indicated, remove the connector.
YAD9D090
10. While connector is linked, insert this until sounds
like tack!, tack!
YAD9D100
11. If electric current is sent or check voltage through
tester of circuit, probe is set from the harness, if
connector is kind of sealing type, probe is set
through hole of cap in the wiring rubber.
At this time, keep in mind, not to damage isolation
of wiring, insert probe until contact connector of
terminal completely.
Notice: Tester of circuit is not used on the air bag
system, while this system is checked, scanner
should be used.
YAD9D110
SSANGYONG Y200