Subaru Legacy 2004 Service Manual page 2648

MANUAL TRANSMISSION AND DIFFERENTIAL
5) Tighten the nuts which hold lower side of trans-
mission to engine.
Tightening torque:
"
50 N m (5.1 kgf-m, 36.9 ft-lb)
6) Connect the transmission to engine.
(1) Install the starter.
<Ref. to SC(H4SO 2.0)-6, INSTALLATION,
Starter.>
(2) Tighten the bolts that hold upper side of
transmission to engine.
Tightening torque:
"
50 N m (5.1 kgf-m, 36.9 ft-lb)
7) Remove the ST.
Manual Transmission Assembly
MT-00077
MT-00073
S T
MT-00070
8) Install the pitching stopper.
Tightening torque:
"
T1: 50 N m (5.1 kgf-m, 37 ft-lb)
"
T2: 58 N m (5.9 kgf-m, 43 ft-lb)
T2
9) Lift-up the vehicle.
10) Install the front drive shaft into transmission.
11) Replace the differential side retainer oil seal.
<Ref. to 5MT-40, REPLACEMENT, Differential
Side Retainer Oil Seal.>
ST 186755AA000 DIFFERENTIAL SIDE OIL
NOTE:
Be sure to replace the differential side retainer oil
seal after the procedure of removing the front drive
shaft.
ST
12) Install the front drive shaft into transmission.
ST 28399SA010 FRONT DRIVE SHAFT OIL
5MT-34
SEAL INSTALLER
SEAL PROTECTOR
ST
T1
MT-00085
MT-00103
AT-00110