C: CAUTION
• Wear work clothing, including a cap, protective
goggles and protective shoes, during operation.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• When disassembling the case and other light al-
loy parts, use a plastic hammer to force it apart. Do
not pry it apart with a screwdriver or other tool.
• Be careful not to burn yourself, because each
part on the vehicle is hot after running.
• Use SUBARU genuine gear oil, grease etc. or
equivalent. Do not mix gear oil, grease etc. with
that of another grade or from other manufacturers.
D: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
ST-399411700
ST-899524100
General Description
TOOL NUMBER
DESCRIPTION
399411700
ACCENT BALL
INSTALLER
899524100
PULLER SET
5MT-17
MANUAL TRANSMISSION AND DIFFERENTIAL
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Apply gear oil onto sliding or revolution surfaces
before installation.
• Replace deformed or damaged snap rings with
new ones.
• Before installing O-rings or oil seals, apply suffi-
cient amount of gear oil to avoid damage and defor-
mation.
• Be careful not to incorrectly install or fail to install
O-rings, snap rings and other such parts.
• Before securing a part on a vice, place cushion-
ing material such as wood blocks, aluminum plate
or cloth between the part and the vice.
• Avoid damaging the mating surface of the case.
• Before applying sealant, completely remove the
old seal.
Used for installing reverse shifter rail arm.
Used for removing and installing roller bearing
(Differential).
(1) Puller
(2) Cap
REMARKS