Subaru Legacy 2004 Service Manual page 2695

5) Remove the 5th driven gear using ST.
ST 499857000 5TH DRIVEN GEAR REMOV-
ER
6) Remove the woodruff key.
7) Remove the roller bearing and 3rd-4th driven
gear using ST1 and ST2.
ST1 499757002 INSTALLER
ST2 899714110 REMOVER
8) Remove the key.
9) Remove the 2nd driven gear, inner baulk ring,
synchro cone and outer baulk ring.
(A) 2nd driven gear
(B) Inner baulk ring
(C) Synchro cone
(D) Outer baulk ring
Drive Pinion Shaft Assembly
S T
MT-00248
ST1
ST2
MT-00249
(D) (A)
(C) (B)
MT-00997
5MT-79
MANUAL TRANSMISSION AND DIFFERENTIAL
10) Remove the 1st driven gear, 2nd gear bushing,
gear and hub using ST1 and ST2.
(A) (B)
(A) 1st driven gear
(B) Inner baulk ring
(C) Hub
(D) 2nd gear bushing
NOTE:
Replace the gear and hub if necessary. Do not dis-
assemble because they must engage at a specified
point. If they have to be disassembled, mark the
engaging point on the spline beforehand.
ST1 499757002 INSTALLER
ST2 899714110 REMOVER
D: ASSEMBLY
1) Install the sleeve and hub assembly by matching
alignment marks.
(C)
(D)
MT-00991
ST1
ST2
MT-00251