Subaru Legacy 2004 Service Manual page 2656

Switches and Harness
MANUAL TRANSMISSION AND DIFFERENTIAL
2) Connect the connectors of back-up light switch
and neutral position switch.
3) Install the air intake chamber and cleaner case.
<Ref. to IN(H4SO 2.0)-7, INSTALLATION, Air
Cleaner Case.> <Ref. to IN(H4SO 2.0)-8, INSTAL-
LATION, Air Intake Chamber.>
4) Connect the battery ground cable to battery.
2. HIGH-LOW SWITCH (DUAL-RANGE
MODEL)
1) Install the high-low switch.
Tightening torque:
"
25 N m (2.5 kgf-m, 18.4 ft-lb)
2) Install the high-low switch cable to clamp.
3) Connect the connector of high-low switch.
4) Install the air intake chamber and cleaner case.
<Ref. to IN(H4SO 2.0)-7, INSTALLATION, Air
Cleaner Case.> <Ref. to IN(H4SO 2.0)-8, INSTAL-
LATION, Air Intake Chamber.>
5) Connect the battery ground cable to battery.
C: INSPECTION
1. BACK-UP LIGHT SWITCH
Inspect the back-up light switch. <Ref. to LI-7, IN-
SPECTION, Back-up Light System.>
2. NEUTRAL POSITION SWITCH
1) Turn the ignition switch to OFF.
2) Disconnect the connector of neutral position
switch.
3) Measure the resistance between neutral posi-
tion switch terminals.
2 1
MT-00110
Gear shift position Terminal No. Specified resistance
Neutral position More than 1 M%
1 and 2
Less than 1 %
Other positions
4) Replace the faulty parts.
5MT-42