Subaru Legacy 2004 Service Manual page 2649

13) Install the ball joint of lower arm.
Tightening torque:
"
49 N m (5.0 kgf-m, 36 ft-lb)
(C)
(A) Front arm
(B) Ball joint
(C) Stabilizer link
14) Install the stabilizer link into front arm.
Tightening torque:
"
45 N m (4.6 kgf-m, 33.2 ft-lb)
15) Install the gear shift rod and the stay.
(1) Install the gear shift rod into transmission.
(A)
(A) Stay
(B) Rod
(2) Install the stay onto transmission.
16) Install the propeller shaft. <Ref. to DS-11, IN-
STALLATION, Propeller Shaft.>
17) Install the heat shield cover. (if equipped)
Manual Transmission Assembly
(B)
(A)
MT-00987
MT-00988
(B) (B)
MT-00089
5MT-35
MANUAL TRANSMISSION AND DIFFERENTIAL
18) Install the hanger bracket on the right side of
transmission.
19) Install the front, center and rear exhaust pipe,
and muffler. <Ref. to EX(H4SO 2.0)-8, INSTALLA-
TION, Front Exhaust Pipe.> <Ref. to EX(H4SO
2.0)-11, INSTALLATION, Rear Exhaust Pipe.>
<Ref. to EX(H4SO 2.0)-13, INSTALLATION, Muf-
fler.>
20) Install the operating cylinder.
Tightening torque:
"
37 N m (3.8 kgf-m, 27.5 ft-lb)
21) Install the drive select cable on transmission
side. (Dual-range model)
( C )
( B )
(A) Snap pin
(B) Clevis pin
(C) Drive select cable
22) Connect the following connectors:
(1) Transmission ground cable
Tightening torque:
"
13 N m (1.3 kgf-m, 9.4 ft-lb)
MT-00074
CL-00253
( A )
MT-00066