Subaru Legacy 2004 Service Manual page 2566

Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
1 CHECK DTC OF TCM.
2 CHECK HARNESS CONNECTOR BETWEEN
TCM AND BACK-UP LIGHT RELAY.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from TCM and
back-up light relay.
3) Measure the resistance of harness
between TCM and back-up light relay connec-
tor.
Connector & terminal
(B55) No. 11 — (B356) No. 1:
3 CHECK HARNESS CONNECTOR BETWEEN
TCM AND TRANSMISSION.
Measure the resistance of harness between
TCM connector and chassis ground.
Connector & terminal
(B55) No. 11 — Chassis ground:
4 CHECK TCM OUTPUT SIGNAL.
1) Turn the ignition switch to ON. (engine
OFF)
2) Shift the select lever to "P" range.
5 CHECK TCM OUTPUT SIGNAL.
Shift the select lever to "R" range.
6 CHECK INPUT VOLTAGE FOR BACK-UP
LIGHT RELAY.
Measure the voltage between back-up light
relay and chassis ground.
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
Check
Is DTC of Transmission Range
Sensor Circuit (PRNDL Input)
circuit detected?
Is the resistance less than 1
"?
Is the resistance more than 1
M"?
Is the voltage more than 10 V? Go to step 5.
Is the voltage less than 1 V?
Is the voltage 10 — 13 V?
5AT(diag)-107
Yes
Perform the diag- Go to step 2.
nosis according to
DTC.
Go to step 3. Repair the open
circuit in harness
between TCM and
transmission con-
nector, and poor
contact in cou-
pling connector.
Go to step 4. Repair the short
circuit in harness
between TCM and
transmission con-
nector.
Replace the TCM.
<Ref. to 5AT-61,
Transmission Con-
trol Module
(TCM).>
Go to step 6. Replace the TCM.
<Ref. to 5AT-61,
Transmission Con-
trol Module
(TCM).>
Replace the back- Check open or
up light relay. short circuit in har-
ness between fuse
(No. 18) and
backup light relay.
No