Subaru Legacy 2004 Service Manual page 2670

MANUAL TRANSMISSION AND DIFFERENTIAL
2) Remove the reverse check plate, reverse check
spring, reverse check cam, return spring (5th-Rev),
reverse accent shaft, return spring cap and return
spring (1st-2nd).
(A)
(C)
(B)
(D)
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
3) Remove the O-ring.
NOTE:
• Visually check the O-ring. Replace if defective.
• Be careful not to break adjustment shim placed
between reverse check sleeve assembly and case.
Reverse Check Sleeve
(E)
(G)
(F)
MT-00154
D: ASSEMBLY
1) Install the return spring (1st-2nd), return spring
cap, reverse accent shaft, check cam, return spring
(5th-Rev.) and reverse check spring onto reverse
check sleeve.
NOTE:
Be sure to position the bent section of reverse
check spring in the groove in check cam.
(B)
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
2) Hook the bent section of reverse check spring
over reverse check plate.
3) Rotate the cam so that the protrusion of reverse
check cam is at the opening in plate.
4) With cam held in that position, install the reverse
check plate onto reverse check sleeve and hold
with snap ring.
5) Position the O-ring in the groove in sleeve.
5MT-54
(A)
(C)
(E)
(D)
(G)
(F)
MT-00154