Subaru Legacy 2004 Service Manual page 2647

23) Using the lever, remove the left and right front
drive shaft from transmission.
(A) Lever
24) Remove the nuts which hold lower side of
transmission to engine.
25) Place the transmission jack under transmis-
sion.
CAUTION:
Always support transmission case with a trans-
mission jack.
Manual Transmission Assembly
(A)
MT-01017
MT-00077
MT-00078
5MT-33
MANUAL TRANSMISSION AND DIFFERENTIAL
26) Remove the transmission rear crossmember
from vehicle.
27) Remove the transmission.
NOTE:
Move the transmission jack toward rear until main
shaft is withdrawn from clutch disc.
28) Separate the transmission assembly from rear
cushion rubber.
B: INSTALLATION
1) Install the rear cushion rubber to transmission
assembly.
Tightening torque:
"
35 N m (3.57 kgf-m, 25.8 ft-lb)
2) Install the transmission onto engine.
(1) Gradually raise the transmission with trans-
mission jack.
(2) Engage them at splines.
NOTE:
Be careful not to strike the main shaft against clutch
housing cover.
3) Install the transmission rear crossmember.
Tightening torque:
"
T1: 70 N m (7.1 kgf-m, 51 ft-lb)
"
T2: 140 N m (14.3 kgf-m, 103 ft-lb)
T 1
T 2
4) Take out the transmission jack.
MT-00079
T 1
T 2
MT-00081