Subaru Legacy 2004 Service Manual page 2679

5) Using the ST1, ST2 and a press, remove the ball
bearing, synchro cone and baulk ring (Rev).
NOTE:
• When replacing the sleeve & hub with new ones,
replace them as a set.
• Do not disassemble the sleeve & hub, because
the aligning position is specified.
• If it is necessary to disassemble, mark the en-
gaging points on the splines beforehand.
• Do not reuse the ball bearing.
ST1 499757002 INSTALLER
ST2 498077400 SYNCHRO CONE REMOV-
ER
ST1
(A)
(A) Ball bearing
(B) Synchro cone
(C) Baulk ring
6) Using the ST1 and ST2, remove the rest of
parts.
NOTE:
• When replacing the sleeve & hub with new ones,
replace them as a set.
• Do not disassemble the sleeve & hub, because
the aligning position is specified.
• If it is necessary to disassemble, mark the en-
gaging points on the splines beforehand.
Main Shaft Assembly for Single-Range
(B)
ST2
(C)
MT-00189
5MT-63
MANUAL TRANSMISSION AND DIFFERENTIAL
ST1 899864100 REMOVER
ST2 899714110 REMOVER
ST2
(A) Push
D: ASSEMBLY
1) When the sleeve & hub assemblies have been
disassembled, reassemble with aligning each en-
gaging point.
(A)
ST1
MT-00190