Subaru Legacy 2004 Service Manual page 2651

4. Transmission Mounting Sys-
tem
A: REMOVAL
1. PITCHING STOPPER
1) Disconnect the ground cable from battery.
2) Remove the air intake chamber. <Ref. to
IN(H4SO 2.0)-8, REMOVAL, Air Intake Chamber.>
3) Remove the air cleaner case. <Ref. to IN(H4SO
2.0)-6, REMOVAL, Air Cleaner Case.>
4) Remove the pitching stopper.
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Disconnect the ground cable from battery.
2) Jack-up the vehicle and support it with rigid
racks.
3) Remove the front, center and rear exhaust pipe,
and muffler. <Ref. to EX(H4SO 2.0)-7, REMOVAL,
Front Exhaust Pipe.> <Ref. to EX(H4SO 2.0)-11,
REMOVAL, Rear Exhaust
EX(H4SO 2.0)-13, REMOVAL, Muffler.>
4) Remove the heat shield cover. (If equipped)
5) Set the transmission jack under transmission
body.
CAUTION:
Always support the transmission case with a
transmission jack.
6) Remove the rear crossmember.
7) Remove the rear cushion rubber.
Transmission Mounting System
MT-00069
Pipe.> <Ref. to
MT-00079
5MT-37
MANUAL TRANSMISSION AND DIFFERENTIAL
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
"
T1: 50 N m (5.1 kgf-m, 37 ft-lb)
"
T2: 58 N m (5.9 kgf-m, 43 ft-lb)
T2
2) Install the air intake chamber and cleaner case.
<Ref. to IN(H4SO 2.0)-7, INSTALLATION, Air
Cleaner Case.> <Ref. to IN(H4SO 2.0)-8, INSTAL-
LATION, Air Intake Chamber.>
3) Connect the battery ground cable to battery.
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Install the rear cushion rubber.
Tightening torque:
"
35 N m (3.6 kgf-m, 26 ft-lb)
2) Install the rear crossmember.
Tightening torque:
"
T1: 70 N m (7.1 kgf-m, 51 ft-lb)
"
T2: 140 N m (14.3 kgf-m, 103 ft-lb)
T 1
T 2
3) Remove the transmission jack.
4) Install the heat shield cover. (If equipped)
5) Install the front, center and rear exhaust pipe,
and muffler. <Ref. to EX(H4SO 2.0)-8, INSTALLA-
TION, Front Exhaust Pipe.> <Ref. to EX(H4SO
2.0)-11, INSTALLATION, Rear Exhaust Pipe.>
<Ref. to EX(H4SO 2.0)-13, INSTALLATION, Muf-
fler.>
6) Lower the vehicle.
7) Connect the battery ground cable to battery.
T1
MT-00085
T 1
T 2
MT-00081