Subaru Legacy 2004 Service Manual page 2646

MANUAL TRANSMISSION AND DIFFERENTIAL
12) Set the ST.
ST 41099AA000 ENGINE SUPPORT ASSY
13) Remove the bolts which hold upper side of
transmission to engine.
14) Lift-up the vehicle.
15) Remove the front and center exhaust pipes.
<Ref. to EX(H4SO 2.0)-7, REMOVAL, Front Ex-
haust Pipe.>
16) Remove the rear exhaust pipe and muffler.
<Ref. to EX(H4SO 2.0)-11, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H4SO 2.0)-13, REMOV-
AL, Muffler.>
CAUTION:
When removing the exhaust pipes, be careful
each exhaust pipe does not drop out.
17) Remove the heat shield cover. (if equipped)
18) Remove the hanger bracket from the right side
of transmission.
19) Remove the propeller shaft. <Ref. to DS-10,
REMOVAL, Propeller Shaft.>
20) Remove the gear shift rod and the stay from
transmission.
Manual Transmission Assembly
S T
MT-00070
MT-00073
MT-00074
(1) Disconnect the stay from transmission.
(2) Remove the rod from transmission.
(A) Stay
(B) Rod
21) Remove the stabilizer link from front arm.
22) Remove the bolt securing ball joint of front arm
to housing.
(C)
(A) Front arm
(B) Ball joint
(C) Stabilizer link
5MT-32
(A)
(B) (B)
MT-00075
MT-00988
(A)
MT-00987
(B)