Subaru Legacy 2004 Service Manual page 2681

ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
7) Using the ST1 and ST2, install the 5th gear
thrust washer and 5th needle bearing race onto the
rear section of transmission main shaft.
NOTE:
• Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
• Face the thrust washer in the correct direction.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A) Face this surface to 5th gear side.
8) Install the bearing onto synchro cone.
9) Install the baulk ring and synchro cone onto 5th-
Rev sleeve & hub assembly using ST and a press.
NOTE:
• Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
• Use new ball bearing.
• Make sure the synchro cone rotates smoothly af-
ter press-fitting.
Main Shaft Assembly for Single-Range
ST2
ST1
MT-00194
(A)
MT-00195
5MT-65
MANUAL TRANSMISSION AND DIFFERENTIAL
ST 499757002 INSTALLER
(A)
(B)
(A) Baulk ring
(B) Synchro cone
(C) Ball bearing
10) Install the synchro cone stopper and snap ring
to 5th-Rev sleeve & hub assembly.
(A) Synchro cone stopper
(B) Snap ring
11) Install the rest of parts to the rear section of
transmission main shaft.
NOTE:
Align the groove in baulk ring with shifting insert.
(A) (B) (C)
(A) Needle bearing
(B) 5th drive gear
(C) Baulk ring
(D) 5th-Rev sleeve & hub ASSY
(E) Lock washer
(F) Lock nuts
ST
(C)
MT-00196
(B)
(A)
MT-00188
(D)
(E)
(F)
MT-00198