Flash Operation Interrupt Enable Register - Oier - Holtek HT32F52220 User Manual

32-Bit Arm ® Cortex ® -M0+ MCU
HT32F52220/HT32F52230
Flash Operation Interrupt Enable Register – OIER
This register is used to enable or disable the FMC interrupt function. The FMC generates interrupts to the
controller when corresponding interrupt enable bits are set.
Offset: 0x014
Reset value: 0x0000_0000
31
Type/Reset
23
Type/Reset
15
Type/Reset
7
Reserved
Type/Reset
Bits Field
[4] OREIEN
[3] IOCMIEN
[2] OBEIEN
[1] ITADIEN
[0] ORFIEN
Rev. 1.10
30 29 28
22 21 20
14 13 12
6 5 4
OREIEN
RW
Descriptions
Operation Error Interrupt Enable
0: Operation error interrupt is disabled
1: Operation error interrupt is enabled
Invalid Operation Command Interrupt Enable
0: Invalid Operation Command interrupt is disabled
1: Invalid Operation Command interrupt is enabled
Option Byte Check Sum Error Interrupt Enable
0: Option Byte Check Sum Error interrupt is disabled
1: Option Byte Check Sum Error interrupt is enabled
Invalid Target Address Interrupt Enable
0: Invalid Target Address interrupt is disabled
1: Invalid Target Address interrupt is enabled
Operation Finished Interrupt Enable
0: Operation Finish interrupt is disabled
1: Operation Finish interrupt is enabled
45 of 366
27 26
Reserved
19 18
Reserved
11 10
Reserved
3 2
IOCMIEN OBEIEN
0 RW 0 RW 0 RW
25 24
17 16
9 8
1 0
ITADIEN ORFIEN
0 RW 0
November 09, 2018