TDT RZ2 Manual page 724

21-10
4. Once you have selected the desired file, click Open. The Open window is
5. For all devices except RX-Series Processors, click Program Device!. For
6. When the Device Programmed message is displayed, click OK.
zBUSmon Interface Testing Software
closed and the selected file appears in the uCode File box.
RX-Series Processors only, press and hold the Mode button on the front
panel of the device then click Program Device!. When Firmware: BLANK
or Firmware: Burning is displayed on the front panel of the device, release
the Mode button.
Programming begins and the progress bar displays the estimated time to
complete the task.
Note: The PC should not be used for other tasks while devices are being
reprogrammed.
The Stop Programming button will halt programming, but the device will
need to be programmed before it can be used.
System 3