TDT RZ2 Manual page 509

System 3
DB26 Pinout
PZ3 amplifiers have up to 16 26-pin headstage connectors on the back of the unit.
The PZ3 channels are marked next to the respective connector on the amplifier.
Match S-BOX DB26 Output connectors to the matching connectors on the PZ3.
Pinout Diagram
Note: There are 8 channels per DB26 connector. Bank A is shown. Subsequent banks are
indexed by an additional 8 channels.
Pin
1 A1
2 NA
3 A2
4 NA
5 Ref
6 NA
7 A3
8 A4
9 A5
10 A6
11 A7
12 A8
13 GND
S‐BOX_PZ5 ‐ Amplifier Input Splitter for the PZ5
The S-BOX_PZ5 is a 32-channel passive signal splitter for use with the PZ5
Amplifier. The splitter provides a simple and effective means of routing low
impedance biological signals to both a TDT acquisition system and a parallel
recording system.
Two DB26 connectors provide direct connection to a PZ5 amplifier and a single
DB37 provides a parallel output connection. Bank letters as well as channel number
ranges are labeled on all the DB26 connectors (i.e. Bank A Channels 1-16).
Important! The S-BOX_PZ5 is NOT FDA approved and is intended for use with the PZ5
Amplifier.
The S-BOX_PZ5 uses standard 1.5 mm safety connectors for input from electrodes.
Front panel numbering of these inputs corresponds to TDT amplifier channels.
Name Description
Analog Output Channel
Not Used
Analog Output Channel
Not Used
Shared Reference
Not Used
Analog Output Channels
Ground
Pin Name Description
14 NA Not Used
15 GND Ground
16 NA Not Used
17 NA
18 NA
19 NA
20 NA
21 NA
22 NA
23 NA
24 NA
25 NA
26 NA
12-27
Splitters