TDT RZ2 Manual page 106

2-10
6. Click OK. The RS4 can now be accessed by the PC.
7. Obtain the RS4 device address. Press the Ports tab on the RS4 interface.
8. Enter the device address as shown in a windows address bar to access the
9. Access the files on the RS4 by reading or writing.
Connecting Through a Network
Connection to a local area network also allows data to be viewed and modified
through the standard Microsoft Windows file sharing protocol from any PC connected
to the same network as the RS4.
To access the RS4 file system through a network:
DHCP must be enabled on the network in order to access the RS4. If DHCP is
disabled or not supported, you can connect the RS4 directly to a PC (see "Direct
RS4 Data Streamer
The device address is displayed at the top of the page to the right of
Device Name field.
RS4 file system.
The path RS4-#XXXX\data is used to access the RS4 storage array.
Where # is the total number of streaming ports on the RS4 back panel,
XXXX is the device serial number while the data folder contains the data
saved to the storage array.
WARNING!: Do not attempt to write to the RS4 storage array at
any time while data is actively streaming. Doing so may corrupt data
currently being stored.
System 3