TDT RZ2 Manual page 582

16-4
Part Numbers:
MF1-M—Mono
MF1-S—Dual (two speakers)
Multi‐Field Configurations
The MF1 speaker is comprised of the free-field speaker and a closed-field adapter,
a tapered tip, and line filter for closed-field use. An RCA to BNC adapter and stand
are also provided.
Using the MF1 for Free Field Operation
The MF1 main speaker component can be used for free-field sound production. The
speaker can be connected to the source via an RCA connector located on the back
of the MF1 housing. If using the stereo amplifier built into the RZ6, simply connect
the supplied RCA cable from the MF1 to one of the output BNC connectors on the
RZ6 using the supplied RCA to BNC adapter.
Caution!: When the speaker is configured for free field use, be careful to
avoid touching the exposed speaker membrane.
Configuring the MF1 for Closed Field Operation
For closed-field operation, the Close Field adapter is attached to the face of the
speaker using three hex screws. A parabolic tip is be mounted in the recessed
socket on the closed-field adapter and is held securely in place by an o-ring at the
base of the tip.
The speaker can be connected to the source via an RCA connector located on the
back of the MF1 housing. If using the stereo amplifier built into the RZ6, simply
connect the supplied RCA cable from the MF1 to one of the output BNC connectors
on the RZ6 using the supplied RCA to BNC adapters.
Important! When using the MF1 in the closed-field configuration the supplied CF line filter must
be installed between the BNC to RCA adapter and the RCA cable. This filter
minimizes distortion at lower frequencies in the closed-field.
MF1 Multi-Field Magnetic Speakers
System 3