TDT RZ2 Manual page 460

System 3 series. rz z series
Table of Contents

Advertisement

10-46
V or less. Check the preamplifier voltage input and power supply specifications and
headstage gain to determine the voltage range of the system.
The table below lists the input voltage ranges for the 16 channel ECoG headstages
for either a +/- 1.5 V or +/- 2.5 V power source.
CB16–PMT
Technical Specifications
Input Referred Noise
Headstage Gain
Input Impedance
Pinout
The numbers on the pinout diagram above show the channel connections to the
amplifier.
A three position switch is used to connect either REFa, REFb, or GND to the REF
line on the DB26 PreAmplifier/Digitizer connector.
The headstage does not provide access to ground and instead relies on the use of
the external ground on the preamplifier/digitizer.
ECoG Headstages
Headstage input range when
using +/- 1.5 V power
source
-1.5 to 1.4 V
rms 3 μV bandwidth 300-3000 Hz
rms 6 μV bandwidth 30-8000 Hz
Unity (1x)
10
Ohms
13
Headstage input range when
using +/- 2.5 V power
source
-2.5 to 2.4 V
System 3

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RZ2 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Related Products for TDT RZ2

Table of Contents

Save PDF