TDT RZ2 Manual page 525

System 3
ZCAP ‐ Aluminum ZIF‐Clip® Cap
The ZCAPn Standard Cap
The ZCAP fits directly over all resin form factor ZIF-Clip® compatible connectors and
features a rubber O-ring for easy handling and grip.
To use the ZCAP:
•
To remove the ZCAP:
•
The ZL‐CAP Locking Cap
The ZL-CAP can only be used with aluminum form factor ZIF-Clip® arrays. It locks
onto the shroud to prevent unintentional removal of the cap by the subject when not
in use. Aluminum shroud arrays and locking caps are recommended for larger test
subjects.
To use the ZL-CAP:
1.
2. Pinch the opposite end of the connector to engage the locking clamp.
To remove the ZL-CAP:
•
Part Number: ZCAP, ZL-CAP
The ZIF-Clip® Caps are made of high quality aluminum and are
designed to protect the ZIF-Clip® micro connector from potential
damage in the absence of the ZIF-Clip® headstage. They can be
used with both ZIF-Clip® probe adapters and microwire arrays.
Grip it with two fingers and gently slide it onto the
ZIF-Clip® micro connector.
Grasp both sides of the O-ring grip and gently pull
away from the ZIF-Clip® micro connector until the
ZCAP releases from the connector.
Pinch the base with two fingers and gently slide it onto the ZIF-Clip® micro
connector.
Pinch the base with two fingers to open the locking clamp and gently slide
it off of the ZIF-Clip® micro connector.
ZIF-Clip® Based Microwire Arrays
13-7