TDT RZ2 Manual page 105

System 3
11. Enter the device address as shown in a windows address bar to access the
12. Access the files on the RS4 by reading or writing.
while data is actively streaming. Doing so may corrupt data currently being stored.
Using Windows XP
To access the RS4 file system through a PC:
1.
2. Right-click the desired connection (this is usually a Local Area Connection)
3. Select Internet Protocol (TCP/IP) or if there are multiples, select Internet
4. Click the Properties button.
5. Select Use the following IP address and enter these values:
a. Press the Ports tab on the RS4 interface.
b. The device address is displayed at the top of the page to the right of
Device Name field.
RS4 file system.
The path RS4-#XXXX\data is used to access the RS4 storage array.
Where # is the total number of streaming ports on the RS4 back panel,
XXXX is the device serial number while the data folder contains the data
saved to the storage array.
WARNING!: Do not attempt to write to the RS4 storage array at any time
You will have to configure the PC TCP/IP settings. Open Control Panel
then double-click Network Connections.
and select Properties.
Protocol (TCP/IPv4).
IP address: 10.1.0.x, where x can be any value from 1 to 254 except 42.
Subnet mask: 255.255.255.0
Default gateway: Leave empty
2-9
RS4 Data Streamer