TDT RZ2 Manual page 11

System 3
Interface
Amp
Touch to Display:
Firmware Version:
Model:
DSP Type:
Sample Rate:
Time Slice:
Component Usage:
Core Cycle Use:
Optical Config:
Memory Usage:
XM => 0 of 65536 kBytes
DM => 0 of 32768 Bytes
PM => 0 of 28672 Bytes
Data Pipe Source:
Pipe[A] => Inactive
Pipe[B] => Inactive
Optical Config is the peripheral device supported by the DSP,
if any.
Data memory (DM) is the amount of DM used for filter delay
line and short delays.
External Memory (XM) is the amount of XM used for long
delays and buffers.
Program Memory (PM) is the amount of PM used to hold filter
coefficients.
Tabs are enabled for quad-core DSPs, with one Core per tab.
Virtual Status lights display status of the interface (Status),
zTrig-A, and zTrig-B. A stacked histogram shows data transfer
rate in mb/s.
Touch to Display:
Firmware version, MB data received/sent and transfer errors.
zBus Interface Detail
Firmware Version: 1.2
MBytes Received: 8.628
MBytes Sent: 384.397
Touch to Display:
Amp model, number of channels and firmware version of
connected PZ series amplifier.
DSP #1 Details
84
RZ2 Bioamp Processor
Quad Core DSP
12 kHz (24414.0625 Hz)
10
0 of 768 Max
0%
None
Errors: 32584
RZ2 BioAmp Processor
1-5