TDT RZ2 Manual page 242

6-34
To power off onboard battery operation:
•
The neurodigitizer uses mains power for charging.
To charge the neurodigitizer:
1.
2. Set the switch on the back panel adjacent to the power connector to the on
Important: If the power circuit doesn't detect the power (from power cord) when set to charge,
charging is not engaged. Be sure the device is plugged in before you switch to
charging.
See "Power Status LEDs" on page 6-51, for more information.
Physical Amplifier
All PZ5M channels are organized into banks, with each bank corresponding to a
group of 64 channels, a rear panel headstage connector (labeled alphabetically),
and a front panel LED displays. Each bank is electrically isolated and can be
independently configured or grouped with other banks and defined as a
amplifier
.
Logical Amplifiers
The PZ5M can have a maximum of four logical amplifiers. Though each bank has its
own ground and reference, a single ground and reference can also be defined and
shared across all banks of the logical amplifier. See "Reference Modes" below. The
diagrams below show possible logical amplifier configurations.
PZ5M Medically Isolated NeuroDigitizer
Press and release the front panel power button.
It may take a minute for the lights to go out.
Ensure the power connector on the neurodigitizer back panel is connected to
a mains power outlet, using the provided AC power cable.
position for charging.
Battery lights are on when charging.
System 3
logical