TDT RZ2 Manual page 650

17-32
To make changes to the configuration:
•
To restore the default values:
•
Network Configuration Page
Note: This page may require authentication. See "Username and Password" on page 17-
30, for more information.
The BH32's IP Address, host name and web username and password can be
changed on this page.
If the Enable DHCP check box is checked, the IP Address, Gateway Address,
Subnet Mask, and DNS server address values are overridden and automatically
configured by the DHCP server if available.
Note: These settings are reserved for connections that cannot locate a DHCP server. If no
DHCP server can be detected, contact your network administrator for applicable
settings.
To change the username and password:
1.
2. Click the Save Config button.
BH32 Behavioral Cage Controller
Type or select the desired values then click the Save Config button. The
Save Config button saves the current configuration settings and performs a
soft reset of the BH32 interface to load the settings.
Click the Reset to Defaults button.
Enter the desired new username and password in the Web User Name and
Web Password boxes.
Note: Once changed, you may need to re-enter the new username and
password to access pages that require authentication, such as the Network
Configuration or Setup pages.
System 3