Rbox Response Box - TDT RZ2 Manual

RBOX Response Box
The RBOX has four buttons for user response and four LEDs that can be used to
provide a subject with feedback. This small, lightweight response box is an affordable
solution for collecting simple subject response data. The RBOX is intended for use as
part of a TDT system with a compatible real-time processor providing control and
response acquisition. There are several versions of the RBOX, each customized for a
particular processor.
Part numbers:
RBOX—Response Box for RP2.1
RBOX4—Response Box for PI2, RM1, or RM2
RBOX_RX6—Response Box for RXn
RBOX_RZ6—Response Box for RZ6
Software Support
PsychRP and SykoFizX software applications for psychophysics provide support for the
RBOX. The response box can also be used with custom designed software developed
using RPvdsEx and TDT's ActiveX or OpenDeveloper tools.
Note: More information on RBOX operation can be found in the
Connecting the RBOX to the Processor
The RBOX must be connected to Digital I/O port on the controlling processor, using
the provided cable. The Digital I/O ports on the RP2.1, RXn, and RZ6 (serial
numbers ?2000) use a DB25 connector. The Digital I/O ports on the RM1/RM2
and RZ6 (serial numbers <2000) use a DB9 connector.
Note: If you are using the RZ6s serial number < 2000 (with a DB9 connector), contact
TDT support for assistance.
The RM1/RM2, RXn, and RZ6 processors require additional RPvdsEx software
configuration for use with the RBOX. See the corresponding sections below for device
specific information.
Buttons and LEDs
The buttons and LEDs are numbered as follows.
17-3
PsychRP Help
.

RBOX Response Box