TDT RZ2 Manual page 81

System 3
7. Click OK.
The UDP interface connection should now be recognized by the PC. Cycle power on
the RZ device, the IP address of the RZ will be 10.1.0.100.
Serial Configuration
The Serial Configuration page on the web interface contains settings for configuring
the serial interface.
Note: If installed in an RZ with 4 optical DSP cards, the serial port is not available.
To change the serial configuration:
1.
2. Enter the username and password to access the Serial Configurations page.
Latest Data Read from Serial Port
If any data has been sent to the RZ serial port, the latest value will be displayed
in this area. ASCII characters represent each byte.
Settings for enabling the serial port, setting baud rate, setting data type and
command formats are located in the Serial Port Settings area.
Click the Serial Configuration link on the left side of the UDP server web
page.
If you have not already entered the username and password, the
authentication dialog box will prompt.
RZ-UDP Communications Interface
1-75