Panasonic FP-E Programming Manual page 146

Basic Instructions
TML
Outline Sets the on-delay timer for 0.001s units
Program example
X0
0
T5
4
Timer contact of timer No. 5
Operands
Relay
Instruction Instruction
WX WY WR
(*1) (*1) (*1)
Set value A A
(*1) This can be used with the FP2SH/FP10SH/FP−X (V2.0 or more)/FPΣ (V3.10 or more)/FP0R.
(*2) This can be used with the FP2/FP2SH/FP10SH.
(*3) This can be used with the FP2SH/FP10SH.
Description
The timer is reset and does not retain its data when the power is turned off or the mode is changed from RUN
to PROG. (If you need to retain the operating state , set system register 6. In that case, a battery must be
used.)
Note) The FP0 T32 is the type with a built−in secondary battery.
When the trigger (execution condition) is on, the set time decrements until the elapsed value reaches zero,
and at this point the timer contact Tn (n represents the timer contact number) goes on.
If the trigger (execution condition) goes off during decrement operation, operation stops and the elapsed
value is reset to zero (cleared).
An OT instruction can appear immediately after a timer coil.
2 − 36
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Timer (0.001s units)
Ladder Diagram Ladder Diagram
Timer instruction number
Timer unit
TML
Timer/
Register
Counter
WL EV DT
SV
(*1) (*1) (*1)
A A A A A
Set value
5, K 300
R0
Index
Constant
register
LD FL
IX IY K
(*1) (*3)
A A N/A N/A A
Boolean
Address Instruction
0 ST X
1 TM L
K
4 ST T
5 OT R
Index
modifier modifier
(*2)
H
A: Available
N/A A
N/A: Not Available
0
5
300
5
0