Step.5:.View.leds - Proxim AP-4000MR-LR Quick Install Manual

step 5: View leds
On most units, the LEDs are present at the unit's Ethernet connector; unscrew
the.watertight.cap.if.necessary.to.view.the.LEDs...
NOTE:.
Make.sure.the.domed.sealing.nut.is.loose.before.unscrewing.the.cap.or.the.
Ethernet.cable.may.be.twisted.and.damaged.
When.the.unit.is.powered.on,.it.performs.startup.diagnostics...When.startup.is.
complete, the LEDs show the unit's operational state, as follows:
LED.State
Blinking.Green
Steady.Green
Note:
On.R1.units,.there.is.one.LED..It.is.the.power.LED.that.appears.in.the.back.
of the unit, between the cooling fins on the right side. (See.Figure.2.)
On power-up, the LED flashes red during initial start-up, and then turns
solid.red.while.booting..After.a.successful.boot,.it.becomes.solid.green.to.
indicate.normal.operation.
Caution!
Before.applying.power.to.the.units,.make.sure.that.a.proper.load.or.
antenna.is.connected.to.each.N-female.jack.to.minimize.the.chance.
of damaging the RF power amplifiers.
Page 16
Power/Ethernet.LED
Power.is.on,.unit.is.booting.up,.
Ethernet..link.is.down.
Power.is.on,.Ethernet..link.is.up.
Radio.LED
Radios.are.being.initialized.
Radios.are.being.operational.
Copyright © 2006 Proxim Wireless