Step 8: View Leds - Proxim ORiNOCO AP-4000MR-LR Quick Install Manual

step 8: View leds

On most units, the LEDs are present at the unit's Ethernet connector; unscrew
the watertight cap if necessary to view the LEDs.
NOTE:
Make sure the domed sealing nut is loose before unscrewing the cap or the
Ethernet cable may be twisted and damaged.
When the unit is powered on, it performs startup diagnostics. When startup is
complete, the LEDs show the unit's operational state, as follows:
LED State
Blinking Green
Steady Green
Note:
On FC units, there is one LED. It is the power LED that appears in the back
of the unit, between the cooling fins on the right side. (See
Figure 4.)
On power-up, the LED flashes red during initial start-up, and then turns
solid red while booting. After a successful boot, it becomes solid green to
indicate normal operation.
Caution!
Before applying power to the units, make sure that a proper load or
antenna is connected to each N-female jack to minimize the chance
of damaging the internal RF power amplifiers.
Page 16
Power/Ethernet LED
Power is on, unit is booting up,
Ethernet link is down.
Power is on, Ethernet link is up.
Radio LED
Radios are being initialized.
Radios are being operational.
Figure 2
Copyright © 2007 Proxim Wireless
and