Management And Monitoring; Proxim Blueconnect; Graphical User Interface - Proxim Edge MP-1035-CPE Device Management Manual

Management and Monitoring

1.1 Management and Monitoring
A Network Administrator can use the following interfaces to configure, manage and monitor the device.
•
Proxim BlueConnect (Bluetooth)
•
Graphical User Interface (GUI)
•
Command Line Interface (CLI)
•
Simple Network Management Protocol (SNMP)
®
•
ProximVision Advanced
For all the modes of operation (except Bluetooth), the IP address of the device should be configured. As each network is
different, a suitable IP address on the network must be assigned to the device. This IP address helps to configure, manage
and monitor the device by using GUI, SNMP, or Telnet/CLI.
For point-to-point and point-to-multipoint devices, the default IP Address is set to static. The pre-configured IP Address for
BSU/End Point A is 169.254.128.132 and for SU/End Point B 169.254.128.131.
You can assign Static or Dynamic IP address to the device. When you select Dynamic, the device obtains IP parameters
automatically from Dynamic Host Configuration Protocol (DHCP) server during boot-up. If the device fails to obtain the IP
address or there is no response from the DHCP server, the device falls back to the IP address 169.254.128.132. Select Static
to manually configure IP parameters.
For IPv6 there are three modes; Static, Dynamic, and Auto.
By default, the device is set to auto mode. In this mode, the device uses Link-local IP Address created from Device MAC
address by default. For Example: If DUT MAC is 04:f5:f4:00:11:05, then IPv6 Link-local IP address is
fe80::6f5:f4ff:fe00:1105/64. The last 6 MAC address octets is used in Link-local.

1.1.1 Proxim BlueConnect

BuleConnect mobile app introduces remote management of a device or peripheral within a range of 15 meters using
Bluetooth Low Energy (BLE) feature. The main purpose of this application is to enable the communication between a mobile
device and any proxim device that supports BLE feature.
With BlueConnect app on your mobile device, you can:
•
Retrieve data from nearby devices.
•
Configure data to a nearby device.
•
Monitor the link status of a device.
•
Configure a device.
•
Reset / reboot a device.
•
: Proxim BlueConnect is only applicable to Edge 1015 and 1025 series.

1.1.2 Graphical User Interface

GUI provides an easy way to configuration settings and retrieve network statistics from any computer on the network. You
can access the GUI through either LAN device, a browser through an Internet connection, or through an Ethernet cable
directly connected to your computer's Ethernet port.
For a secure communication between the device and the HTTP client, the device supports and maintains TLS 1.2 with a
256-bit encryption certificate. All communications are encrypted by using the server and the client-side certificate.
Device Management Guide
1
7