ORiN
Commands
This chapter describes the commands that can be issued using the Access Point's Web browser interface (that is, the
options accessible after clicking the Commands button).
•
Download:
Download files from a TFTP server to the Access Point.
•
Upload:
Upload files from the Access Point to a TFTP server.
•
Reboot:
Reboot the Access Point in the specified number of seconds.
•
Reset:
Reset all of the Access Point's configuration settings to factory defaults.
•
Help Link:
Configure the location where the Access Point's Help files can be found.
NOTE: See
Logging into the Web Interface
Download
Use the Download tab to download AP Image, Bootloader, Configuration, and Generic files from a TFTP server to the
Access Point.
NOTE: The Download and Upload commands are from the AP's perspective. In other words, to send files to the AP,
use the Download command; to obtain files from the AP, use the Upload command.
A TFTP server must be running and configured to point to the directory containing the file. If you don't have a TFTP
server installed on your system, install the TFTP server from the ORiNOCO CD. You can either install the TFTP server
from the CD Wizard or run OEM-TFTP-Server.exe found in the CD's Xtras/SolarWinds/ sub-directory.
Figure 7-1
Download Command Screen
File Type Overview
For Downloads, the File Type parameter supports four options: Config, Img, BspBl, and Generic. For Uploads, File
Type supports two options: Config and Generic.
for instructions on how to access the AP's Web browser interface.
7
181