Mechanically Restricting The Working Range Of Axis 1 - ABB IRB 760 Product Manual

2.4.2 Mechanically restricting the working range of axis 1

General
The working range of axis 1 is limited by fixed mechanical stops and adjustment
of the system parameter configuration. The working range can be reduced by
adding additional mechanical stops giving 7.5 or 15 graduation, between 22.5°
and 135° in both directions.
Mechanical stops, axis 1
The illustration shows the mounting position of the stop pin and one of the additional
mechanical stops available for axis 1.
xx0300000049
A
B
Required equipment
Equipment, etc.
Mechanical stop for axis 1, 7.5°
Mechanical stop for axis 1, 15°
Standard toolkit
Technical reference manual - System
parameters
3HAC039838-001 Revision: C
2.4.2 Mechanically restricting the working range of axis 1
Additional mechanical stop
Stop pin
© Copyright 2013 ABB. All rights reserved.
2 Installation and commissioning
Art. no. Note
3HAC11076-1 Includes attachment screws and
an assembly drawing.
3HAC11076-2 Includes attachment screws and
an assembly drawing.
- Content is defined in section
Standard tools on page
- Art. no. is specified in section
References on page
Continues on next page
351.
10.
93