Table of Contents
Advertisement
6 Decommissioning
6.2 Decommissioning of balancing device
6.2 Decommissioning of balancing device
General
There is much energy stored in the balancing device. Therefore a special procedure
is required to dismantle it. The coil springs inside the balancing device exert a
potentially lethal force unless dismantled properly.
The device must be dismantled by a decommissioning company.
Required equipment
Equipment
Standard toolkit
Protective clothing that also covers
face and hands
Cutting torch with a long shaft
Other tools and procedures may be
required. See references to these
procedures in the step-by-step in-
structions below.
Action on field, decommissioning
The procedure below details the actions to perform on field, when the balancing
device is to be decommissioned.
1
2
Continues on next page
340
DANGER
Do not under any circumstances, deal with the balancing device in any other
way than that detailed in the product documentation! For example, attempting
to open the balancing device is potentially lethal!
Action
Remove the balancing device from the robot.
Send the device to a decommissioning
company.
© Copyright 2013 ABB. All rights reserved.
Art. no.
Note
-
Content is defined in section
tools on page
-
Must protect against spatter of sparks
and flames.
-
For opening housing and cutting coils.
The long shaft is a safety requirement.
These procedures include references
to the tools required.
Note
Make sure the decommissioning com-
pany is well informed about the stored
energy built up by high tensioned com-
pression springs and that the device
contains some grease and plastic.
The following procedure contains useful
information about decommissioning.
3HAC039838-001 Revision: C
Standard
351.
Advertisement
Table of Contents
