Table of Contents
Advertisement
4 Repair
4.3.5 Replacing the base, including axis 1 gearbox
Continued
5
6
7
8
Continues on next page
182
Action
Lift the complete arm system and move it at
very low speed to the mounting site, making
sure it does not tip!
Note
The refitting must be made completely level!
Make sure the roundslings are adjusted prior
to refitting the arm system.
Fit two guide pins in opposite holes in the
frame.
Tip
In order to make refitting easier it is recom-
mended to use two guide pins of different
lengths. Notice that longer guide pins than
140 mm will not be possible to remove after
refitting because of lack of space.
Look through the empty mounting hole of the
axis 1 motor to assist in aligning the as-
sembly during refitting of the complete arm
system.
Lower the complete arm system with guid-
ance from the guide pins previously fitted to
the axis 1 gearbox.
Note
The refitting must be made completely level!
Make sure the roundslings are adjusted prior
to refitting the arm system.
© Copyright 2013 ABB. All rights reserved.
Note
Note
Make sure all hooks and attachments stay
in the correct position while lifting the arm
system and that the lifting accessory does
not wear against sharp edges.
xx1100000258
Dimension is specified in
equipment on page
178.
Note
Always use guide pins in pairs.
CAUTION
This is a complex task to be performed
with utmost care in order to avoid injury
or damage!
Use a crank to turn the gearbox in order
to find the right position for the holes.
3HAC039838-001 Revision: C
Required
Advertisement
Table of Contents
