Table of Contents
Advertisement
4 Repair
4.3.2 Replacing the cable harness, upper end (incl. axis 6)
Continued
10
11
12
170
Action
Refit the cover, motor axis 6 with its attach-
ment screws and washers. Make sure the
cabling is placed correctly when refitting
the cover and does not get jammed.
Note
Make sure the cover is tightly sealed!
Update the revolution counter!
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section
- First test run may cause injury or damage!
on page
45.
© Copyright 2013 ABB. All rights reserved.
Note
xx1000001106
Detailed in section
counters on page
DANGER
3HAC039838-001 Revision: C
Updating revolution
335.
Advertisement
Table of Contents
