Table of Contents
Advertisement
5
6
7
8
9
3HAC039838-001 Revision: C
4.3.2 Replacing the cable harness, upper end (incl. axis 6)
Action
Refit the metal clamp at the tilthouse with
its nuts.
Push the axis 6 motor cables carefully
through the cable gland.
Note
Do not twist the cables!
Reconnect all connectors in motor axis 6.
Check the gasket. If damaged, replace it.
Refit the cable gland with its attachment
screw.
© Copyright 2013 ABB. All rights reserved.
Note
xx1000001336
xx0600002694
•
A: Screw holding the cable gland
Make sure the gasket is not damaged!
Replace if damaged.
Continues on next page
4 Repair
Continued
A
169
Advertisement
Table of Contents
