Table of Contents
Advertisement
2
3
4
5
6
7
8
9
10
3HAC039838-001 Revision: C
Action
xx0200000023
WARNING!
The unit is sensitive to ESD. Before handling the
unit please read the safety information in the
section
WARNING - The unit is sensitive to ESD!
on page 48
Connect the battery cable to the SMB unit.
Connect all connectors to the SMB board:
R1.SMB1-3, R1.SMB6 and R2.SMB
Fit the SMB unit onto the pins.
Secure the SMB unit to the pins with the nuts
and washers.
If disconnected, reconnect the connectors X8,
X9 and X10 to the brake release board.
Secure the SMB cover with its attachment
screws.
Update the revolution counter!
DANGER
Make sure all safety requirements are met when
performing the first test run. These are further
detailed in the section
DANGER - First test run
may cause injury or damage! on page
© Copyright 2013 ABB. All rights reserved.
4.3.3 Replacing the SMB unit
Note
Shown in the figure
unit on page
171.
Art. no. is specified in
equipment on page
Shown in the figure
unit on page
171.
Shown in the figure
unit on page
171.
See
Updating revolution counters on
page
335.
45.
4 Repair
Continued
Location of SMB
Required
171.
Location of SMB
Location of SMB
173
Advertisement
Table of Contents
