Lldp Commands; Introduction; Chapter 42: Lldp Commands - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

42

Introduction

Overview LLDP and LLDP-MED can be configured using the commands in this chapter, or by
using SNMP with the LLDP-MIB and LLDP-EXT-DOT1-MIB (see the
Allied Telesis Enterprise MIBs in AlliedWare
The Voice VLAN feature can be configured using commands in
chapter.
For more information about LLDP, see the
Configuration
LLDP can transmit a lot of data about the network. Typically, the network
information gathered using LLDP is transferred to a Network Management System
by SNMP. For security reasons, we recommend using SNMPv3 for this purpose (see
the
LLDP operates over physical ports only. For example, it can be configured on switch
ports that belong to static or dynamic channel groups, but not on the channel
groups themselves.
Command List •
•
•
•
•
•
•
•
•
•
•
613-50157-01 Rev C

LLDP Commands

Guide.
SNMP Feature Overview and Configuration
"clear lldp statistics" on page 1569
"clear lldp table" on page 1570
"debug lldp" on page 1571
"lldp faststart-count" on page 1573
"lldp holdtime-multiplier" on page 1574
"lldp management-address" on page 1575
"lldp med-notifications" on page 1576
"lldp med-tlv-select" on page 1577
"lldp non-strict-med-tlv-order-check" on page 1580
"lldp notification-interval" on page 1581
"lldp notifications" on page 1582
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Plus).
VLAN Commands
LLDP Feature Overview and
Guide).
Support for
1567