Smartsite Infusion Set (Pump Module); Safety Clamp Fitment (Pump Module) - Cardinal Health Alaris 8000 Series Directions For Use Manual

Administration Set / Syringe Information (Continued)
SmartSite
1. Prior to every access, swab top of SmartSite
Free Valve ("Needle-Free Valve") port with
alcohol ( - seconds) and allow to dry (approximately
1 2
seconds).
2. Prime valve port. If applicable, attach syringe to Needle-
Free Valve port and aspirate miniscule air bubbles.
3. Replace every
72
whichever occurs first. For infusions of blood, blood
products or lipid emulsions, replace every
NOTE:
Dry time is dependent on area temperature, humidity and
ventilation.
Safety Clamp Fitment (
The primary administration set's safety clamp fitment is a
unique clamping device, on the pumping segment, that
prevents inadvertent free-flow when the administration set is
removed from the instrument.
Safety Clamp Fitment in Open Position
When a new Alaris
®
administration set is removed from the package, the safety
clamp fitment is in the open position (white slide clamp aligned
with blue fitment). In this open position, flow is not occluded
but is allowed as required for the priming process. The roller
clamp is used to control flow during the priming process.
2-78
General Information
Infusion Set (
® Pump Module
hours or after
100
Pump Module
Pump Module/Gemini Infusion System
)
Needle-
®
isopropyl
70%
30
activations,
hours.
24
)
FU
CHANNEL
SELECT
PAUSE
CHANNEL
OFF
RESTART
CAUTIONS
• If the Needle-Free Valve is
accessed by a needle in an
emergency, the valve will be
damaged, causing leakage.
Replace Needle-Free Valve
immediately.
• The Needle-Free Valve is
contraindicated for blunt
cannula systems.
• Do not leave slip luer syringes
unattended.
FU
CHANNEL
SELECT
PAUSE
CHANNEL
OFF
RESTART
Blue Fitment
White Slide Clamp
(shown in open position)
Alaris System Directions for Use
®
Pump and Syringe Modules Section