Display references throughout this procedure are for
illustration purposes only.
Reference "General Information", "Features and Displays" and
PC Unit Section of this
• Displays
• Operating Features, Controls, Indicators
1.
Perform following steps (reference PC Unit Section of this
, "General Setup and Operation", "Start-Up"):
DFU
a. Power on system.
b. Choose Yes or No to New Patient?
c. Confirm current profile or select a new profile.
d. Enter patient identifier, if required.
2.
Connect Microstream
Started").
3.
Press
CHANNEL SELECT
•
SENSOR WARMING
Channel Message display until
rate readings stabilize (up to
4.
To change settings, reference "Setting Alarm Limits"
procedure.
OR
-- Continued on Next Page --
Alaris
System Directions for Use
®
EtCO
Module Section
2
for information on the following:
DFU
Monitoring Mode
Disposable (reference "Getting
®
key.
and then
SEARCHING
t
E
CO
2
seconds).
60
appear in
and respiratory
Programming
EtCO (mm Hg)
2
RR (breaths/min)
CHANNEL
SELECT
MONITOR
CHANNEL
OFF
5-5
Programming