Secondary Infusion - Cardinal Health Alaris 8000 Series Directions For Use Manual

2. Press
CHANNEL SELECT
3. Program infusion (reference applicable module-specific
Section of this
DFU
NOTES:
The Alaris System determines if the module selected is
®
appropriate for the scanned medication type. If the selection
is not appropriate (for example, a bag was scanned but a
Module channel was selected), a pop-up warning displays
with a request to
cancelled.
If a continuous Guardrails
checks to verify scanned and infusing medication and
concentration are the same. If not, an error message displays
with a request to
cancelled.
To start a secondary infusion while a primary infusion is in
progress:
1. To scan bar code on
key on Auto-ID Module or scan trigger on hand-held
scanner.
2. Press
CHANNEL SELECT
• Primary infusion parameters display.
3. Press
SECONDARY
4. Program secondary infusion (reference Pump Module
Section of this
DFU
Alaris System Directions for Use
®
Auto-ID Module Section
Primary Infusion (Continued)
key on appropriate module.
).
the message, and the scan is
CONFIRM
Infusion is running, the system
®
the message, and the scan is
CONFIRM

Secondary Infusion

container, press
IV
key on appropriate module.
soft key.
).
PCA
/
SCAN CANCEL
CAUTIONS
•
CLASS 1 LED PRODUCT
stare into the beam or allow
beam to strike patient's face.
• Always verify that information
displayed on the PC Unit
matches scanned data.
Programming
: Do not
6-7